sv800
Active Member
UBE from Scheduler suddenly stops working apparently with corrupted specs.
UBE’s are ending without errors but are not picking any data.
Output: No data selected.
For example R42118 Release backorders didn’t pick any data (no data selected)
Then UBE submitted manually and print 3 pages.
Next run by scheduler it’s fine again.
Looks data selection (specs) is getting corrupted time by time.
The error is coming back days later.
This problem came with SP18.1, we did not have it with SP15.1
Suggestions?
UBE’s are ending without errors but are not picking any data.
Output: No data selected.
For example R42118 Release backorders didn’t pick any data (no data selected)
Then UBE submitted manually and print 3 pages.
Next run by scheduler it’s fine again.
Looks data selection (specs) is getting corrupted time by time.
The error is coming back days later.
This problem came with SP18.1, we did not have it with SP15.1
Suggestions?