• Introducing Dark Mode! Switch by clicking on the lightbulb icon next to Search or by clicking on Default style at the bottom left of the page!

Starting C Debugger in Oneworld

Oneworld B732.2 Manufacturing Minicum
NT - MSSQL


I hope someone can assist with this problem.

I am attempting to start the C debugger in this version of the software to
debug a problem with a business function. Each time I run the software I
get an error from the UBEPRINT.EXE routine.

JDENET Net program ended, pid = 369, signal = 11

The UBEPRINT.exe runs as far as displaying the prompt options, and then
switches to the MS Visual Studio, but then stops and the cursor never is
highlighted on the breakpoint.

Any advice or comments would be greatly appreciated.

Steve Schofield
Aimtronics
Canada.
 

Christian Audet

Moderator
Staff member
Hi Steve,

I don't know all the step that you did to invoke the debuger but make sure you follow all the step on the attached word document. There was some change in the way we should build business function starting with B733.1.

Since you are under B732.2 follow this document but use the "compile in debug mode" option.

If you follow thoses step it should work, it's working 100% of the time for me and I am debuging C business function at least 5 time a week.

Christian Audet


Christian

B7332 SP11, NT4, SQL
(Support B732, B7331 Also implementing Xe)
 

Attachments

Bill_Feeney

Active Member
Hi Christian,
I was reading your response but the attachment wasn't included. Could you
please re-send it?

Thanks very much,

Bill Feeney
medibuy, San Diego
JDE Technical Developer
 

Adrian_Chimirel

Legendary Poster
Re: RE: Starting C Debugger in Oneworld

Are you on the Forum Bill? I'm asking 'cause I saw & downloaded the attachment yesterday!

LIVE: B732.1 SP12.2, Oracle 806
SANDBOX: Xe SP15, Oracle 8i
RS/6000, Citrix
 

Christian Audet

Moderator
Staff member
Re: RE: Starting C Debugger in Oneworld

Hi Bill

OK I will answer you and a lot of people that was asking for it.

Yes the attachment is there !

It`s just because when you do a post with a attachment the attachment is in the forum. So you need to go to the forum in this post queue and at the left of my post you can see "attachment", then you can right clic on it and say "save target as".

To go the forum in the the right queue you just have to clic at the end of my post where you see :

"To view this thread, visit the JDEList forum at:" and then you will see the entire queue and my attachment is there.

If you need more info then it will be my pleasure !




Christian

B7332 SP11, NT4, SQL
(Support B732, B7331 Also implementing Xe)
 

Christian Audet

Moderator
Staff member
Steve,

I hope that you got the attachment, and I will ask you and everybody that are using this Word document, if you find anything in this document that is not working under certain version or platform, can you tell me so I will update the document.

Thanks ! have a good day !




Christian

B7332 SP11, NT4, SQL
(Support B732, B7331 Also implementing Xe)
 
Christian,

Thanks, I found the document where you said it would be. Following the
instructions everything now works. Thanks for your help.

Steve.
 

Bill_Feeney

Active Member
RE: RE: Starting C Debugger in Oneworld

Hi Adrian,
Yes I'm on the forum (very new) and didn't realize that the attachments were
there.

Steve cleared it up for me and I downloaded it.

Thanks to all for this great list!

Bill Feeney
JDE Technical Developer
B733.2, SP 13.1, Unix, Oracle 8.1.6
 
Top