SteveSchofield
Member
Oneworld B732.2 Manufacturing Minicum
NT - MSSQL
I hope someone can assist with this problem.
I am attempting to start the C debugger in this version of the software to
debug a problem with a business function. Each time I run the software I
get an error from the UBEPRINT.EXE routine.
JDENET Net program ended, pid = 369, signal = 11
The UBEPRINT.exe runs as far as displaying the prompt options, and then
switches to the MS Visual Studio, but then stops and the cursor never is
highlighted on the breakpoint.
Any advice or comments would be greatly appreciated.
Steve Schofield
Aimtronics
Canada.
NT - MSSQL
I hope someone can assist with this problem.
I am attempting to start the C debugger in this version of the software to
debug a problem with a business function. Each time I run the software I
get an error from the UBEPRINT.EXE routine.
JDENET Net program ended, pid = 369, signal = 11
The UBEPRINT.exe runs as far as displaying the prompt options, and then
switches to the MS Visual Studio, but then stops and the cursor never is
highlighted on the breakpoint.
Any advice or comments would be greatly appreciated.
Steve Schofield
Aimtronics
Canada.