leggleston
Active Member
I have a custom UBE that works without a problem. I need to copy the UBE and then I can begin work on the copied report. I copy the UBE, add a version, and run a quick test to make sure everything came across correctly. What happens is that the UBE will run for a split second, and stop...no .pdf gets generated even to say there's an error. I run the original, and everything is fine.
Compared my data selection and it's the same, compared each line of ER and it's the same. The copied UBE's ER validates.
I then tried to debug it. After getting all the variables set up in debug, I run the UBE, and it does the same thing (runs for a split second) and the debugger doesn't even kick off.
Has anyone experienced this before?
Thank you,
Lee
Compared my data selection and it's the same, compared each line of ER and it's the same. The copied UBE's ER validates.
I then tried to debug it. After getting all the variables set up in debug, I run the UBE, and it does the same thing (runs for a split second) and the debugger doesn't even kick off.
Has anyone experienced this before?
Thank you,
Lee