b_gilmore
Well Known Member
Has anyone installed Service Pack 8.93_D1 yet on an AS/400 V5R2 for 8.9 or
8.10? It became available on 7/13.
Tried to put it on per the instructions. Once I get to the point where you
run the LINKBSFN, I will run this command against a parent package for a 8.9
pathcode. I will see all the compile jobs for the Service Programs enter the
QBATCH jobq. Then these jobs (about 30 in total) all complete successfully in
less than 10 seconds.
The only thing in the OUTQ for any of these jobs (I used
CALLBSFN/044933/ONEWORLD as an example) produces the following:
QPRINT.SPLF
/B9SYS/ini/jde.iØ
I have verfied the /b9sys/ini/jde.ini is in the correct location and set
properly and have tried to set the jobd for ONEWORLD up to *SECLVL which does
produce a QPJOBLOG but there is nothing in this log indicating a problem.
Also nothing in the /JDEB9/*.logs
We put on 8.93_C1 about 30days back following the same instructions and did
not have any problems.
Just entered a call into PSFT but wondered if anyone else was see this.
8.10? It became available on 7/13.
Tried to put it on per the instructions. Once I get to the point where you
run the LINKBSFN, I will run this command against a parent package for a 8.9
pathcode. I will see all the compile jobs for the Service Programs enter the
QBATCH jobq. Then these jobs (about 30 in total) all complete successfully in
less than 10 seconds.
The only thing in the OUTQ for any of these jobs (I used
CALLBSFN/044933/ONEWORLD as an example) produces the following:
QPRINT.SPLF
/B9SYS/ini/jde.iØ
I have verfied the /b9sys/ini/jde.ini is in the correct location and set
properly and have tried to set the jobd for ONEWORLD up to *SECLVL which does
produce a QPJOBLOG but there is nothing in this log indicating a problem.
Also nothing in the /JDEB9/*.logs
We put on 8.93_C1 about 30days back following the same instructions and did
not have any problems.
Just entered a call into PSFT but wondered if anyone else was see this.
