eydeak
VIP Member
Hello List,
I'm running into an issue with P0911Z1 where you select a row from the "Work With" (Find/Browse) form, but the Revisions (Headerless Detail) form is opening in Add Mode.
We have many sources feeding data into the F0911Z1 and we have not encountered this issue before. I'm working on a new data feed, and some of the batches open in Update mode correctly and some of the batches open in Add mode. I've looked at the batches in UTB and the data is there. It is very consistent about which ones it opens and which ones it doesn't. So, I think it must have something to do with the data, but I don't know how JDE is deciding whether to be in Add or Update mode.
I've stepped through the debugger and on both a "good" batch and a "bad" batch, all of the FI values are being populated will valid values. When I continue to step through the "good" batch as it goes into the Revisions form, the SV Form Mode is BOB MODE UPDATE and that value remains as it goes from the Dialog Is Initialized Event to the Post Dialog is Initialized event. When I step through the "bad" batch, in the Revisions Form Dialog is Initialized event SV Form Mode says it is BOB MODE UPDATE, however the next event to fire is Clear Screen Before Add and SV Form Mode changes to BOB MODE ADD.
Has anybody seen this happen before? Any suggestions as to what else I can look at in debug that might help me figure it out?
Thanks,
I'm running into an issue with P0911Z1 where you select a row from the "Work With" (Find/Browse) form, but the Revisions (Headerless Detail) form is opening in Add Mode.
We have many sources feeding data into the F0911Z1 and we have not encountered this issue before. I'm working on a new data feed, and some of the batches open in Update mode correctly and some of the batches open in Add mode. I've looked at the batches in UTB and the data is there. It is very consistent about which ones it opens and which ones it doesn't. So, I think it must have something to do with the data, but I don't know how JDE is deciding whether to be in Add or Update mode.
I've stepped through the debugger and on both a "good" batch and a "bad" batch, all of the FI values are being populated will valid values. When I continue to step through the "good" batch as it goes into the Revisions form, the SV Form Mode is BOB MODE UPDATE and that value remains as it goes from the Dialog Is Initialized Event to the Post Dialog is Initialized event. When I step through the "bad" batch, in the Revisions Form Dialog is Initialized event SV Form Mode says it is BOB MODE UPDATE, however the next event to fire is Clear Screen Before Add and SV Form Mode changes to BOB MODE ADD.
Has anybody seen this happen before? Any suggestions as to what else I can look at in debug that might help me figure it out?
Thanks,