JMR
VIP Member
I am not very cnc literate and we currently do not have access to the cnc knowledge level required to troubleshoot this, so I thought I'd throw out to the List...
Problem: using html, when we go to batch versions (BV) and submit a report, the printer name is coming up as '*NONE' and there is an error on the Paper Type tab stating the paper type is not valid. The paper type is coming in as blank. The visual assist brings up the paper type selection app, but no records exist (I assume this is because there is no paper type setup for a non-existent *NONE printer).
Using a fat client, all works fine. When submitting and prompted with the printer selection screen, the printer is already pre-loaded and thus the paper type is also.
What is causing this difference between the two? Why does html suck so bad? What is the fastest land animal in world?
TIA
Problem: using html, when we go to batch versions (BV) and submit a report, the printer name is coming up as '*NONE' and there is an error on the Paper Type tab stating the paper type is not valid. The paper type is coming in as blank. The visual assist brings up the paper type selection app, but no records exist (I assume this is because there is no paper type setup for a non-existent *NONE printer).
Using a fat client, all works fine. When submitting and prompted with the printer selection screen, the printer is already pre-loaded and thus the paper type is also.
What is causing this difference between the two? Why does html suck so bad? What is the fastest land animal in world?
TIA