carlo.buhay
Member
Hello!
When I attempt to start debug (by clicking on Debug Application in JDE Solution) I get a pop-up that says, "The parameter is incorrect.".
Clicking the OK button of the pop-up will display the ER Debugger screen.
But when I select an object to debug, the pop-up comes up again and basically could not proceed from there.
I am using a fat client and before I had this problem my machine shut off due to low power.
Any suggestions?
I am new to E1.
I did try to look for a discussion about the matter but did not find any.
When I attempt to start debug (by clicking on Debug Application in JDE Solution) I get a pop-up that says, "The parameter is incorrect.".
Clicking the OK button of the pop-up will display the ER Debugger screen.
But when I select an object to debug, the pop-up comes up again and basically could not proceed from there.
I am using a fat client and before I had this problem my machine shut off due to low power.
Any suggestions?
I am new to E1.
I did try to look for a discussion about the matter but did not find any.