johndanter
Legendary Poster
Hi List,
I have an issue here in that a line split 50 times is behaving very weird
1.000 for 50 units across 50 lots (one unit in each for simplicity) should be split as follows
1.000 > 1.0050
It isn't
It's going
1.000 > 1.012 and then jumping to 1.101 1.201 then 2.001 2.002 etc
Looking at this DOC E1: 42: Split Sales Order and Line Number Assignment (Doc ID 1430995.1) it seems very complicated.
Is there anywhere in E1 that could control this 1.012 to line 2.001 jump???
Update
The differing splits are due to different processes
N4900330 = Approve Shipment
N4201360 = Pick Slips Inv Commitment
EP42118 = Back Order Release
So I need to try and find out where in E1 you can configure this to be 0.001 in all cases
Alias is LNIC I think??
I have an issue here in that a line split 50 times is behaving very weird
1.000 for 50 units across 50 lots (one unit in each for simplicity) should be split as follows
1.000 > 1.0050
It isn't
It's going
1.000 > 1.012 and then jumping to 1.101 1.201 then 2.001 2.002 etc
Looking at this DOC E1: 42: Split Sales Order and Line Number Assignment (Doc ID 1430995.1) it seems very complicated.
Is there anywhere in E1 that could control this 1.012 to line 2.001 jump???
Update
The differing splits are due to different processes
N4900330 = Approve Shipment
N4201360 = Pick Slips Inv Commitment
EP42118 = Back Order Release
So I need to try and find out where in E1 you can configure this to be 0.001 in all cases
Alias is LNIC I think??
Last edited: