ztoreki
Active Member
Hello list,
I have just installed a OneWorld XE on an AS/400 as an enterprise server. All the installation steps were successful, the joblogs are OK. I am trying to sign on with userid ONEWORLD and I cannot reach the menu A98OWMNU.
Here are some messages from the joblog;
Data was truncated on an input, output or update operation.
End of file detected for file INI in B7334SYS.
Cannot process subfile request for file BV3 in library QGPL.
Cannot read record BLDCTL from file BV3 at device QPADEV000I.
Cannot process subfile request for file BV3 in library QGPL.
I can reach the above mentioned menu by typing the command GO A98OWMNU. As far as I remember this menu should be displayed after signing on. The other problem is that I cannot start the server jobs. If I type option 13 to start the server or 14 to stop it, an error message tells me that; "Command ENDNET / STRNET in library *libl not found." So the library list is not set correctly.
One more thing; I have checked for these command, they are located in the library B7334SYS. I have tryied to add this library manually to the library list, the result is that the subsystem starts, the server jobs are start but end normally just immediatelly.
Could anyone help me, please?
Thanks in advance.
Zoltán
I have just installed a OneWorld XE on an AS/400 as an enterprise server. All the installation steps were successful, the joblogs are OK. I am trying to sign on with userid ONEWORLD and I cannot reach the menu A98OWMNU.
Here are some messages from the joblog;
Data was truncated on an input, output or update operation.
End of file detected for file INI in B7334SYS.
Cannot process subfile request for file BV3 in library QGPL.
Cannot read record BLDCTL from file BV3 at device QPADEV000I.
Cannot process subfile request for file BV3 in library QGPL.
I can reach the above mentioned menu by typing the command GO A98OWMNU. As far as I remember this menu should be displayed after signing on. The other problem is that I cannot start the server jobs. If I type option 13 to start the server or 14 to stop it, an error message tells me that; "Command ENDNET / STRNET in library *libl not found." So the library list is not set correctly.
One more thing; I have checked for these command, they are located in the library B7334SYS. I have tryied to add this library manually to the library list, the result is that the subsystem starts, the server jobs are start but end normally just immediatelly.
Could anyone help me, please?
Thanks in advance.
Zoltán