Nishant
Member
RE: how to make a section showing on report not in top down basis
for 1)
Make the section 6 as conditional and then call it from section-4
it wont again b printed after sec-5 and will only b called after sec-4..
for2)
also use the setappendflag( ) with the value to explicitly declare the
conditions again...in another section..
R u using the SetUserSelection(argument1,=3D,argument2,arg4 ) with the correct
value in the last field i.e. arg4
coz it depends on this value that it will "and" or "or" the next condition
with that of the previous one....
Njoy....and tell me if it worked...
Nishant Rewri
(Software Development Group)
PerotSystems TSI (India) Ltd.
Plot No. 3, Sector 125, Noida (U.P.)
India - 201 301
Phone : 0091-120-2432750-64
Friendship creates an "us" without destroying the "me"....
for 1)
Make the section 6 as conditional and then call it from section-4
it wont again b printed after sec-5 and will only b called after sec-4..
for2)
also use the setappendflag( ) with the value to explicitly declare the
conditions again...in another section..
R u using the SetUserSelection(argument1,=3D,argument2,arg4 ) with the correct
value in the last field i.e. arg4
coz it depends on this value that it will "and" or "or" the next condition
with that of the previous one....
Njoy....and tell me if it worked...
Nishant Rewri
(Software Development Group)
PerotSystems TSI (India) Ltd.
Plot No. 3, Sector 125, Noida (U.P.)
India - 201 301
Phone : 0091-120-2432750-64
Friendship creates an "us" without destroying the "me"....
