Sef
VIP Member
This tip was suggested by Zoltan Gyimesi
Q: How to set selection on List of Values inside a UBE?
A:
1.) Create a dummy section with the same Business View.
2.) Define Data Selection for the dummy section in the Section menu. The Range of Values and List of Values tab will be now available for you.
3.) Use the "Use Data Sel/Seq from a Section" System Function (General Category) in your original Section.
Some more test results (by Sef):
The solution works a treat. There's even no need to call this section at all. All you need to do is create it and hide it.
It seems the following "hierarchy" exists when selection statements interact:
When you use 'Set User Selection' with 'Use Data sel/seq from a section', only the 'Set User Selection' is used.
When you set 'Set selection append flag' = Yes and add some data selection at run time, only the 'Use Data sel/seq from a section' is used.
Sef van den Nieuwelaar
Australia
B732 on NT, XE on NT, B732/A73 on AS400, B733 on NT<P ID="edit"><FONT SIZE=-1>Edited by Sef on 12/16/01 09:44 PM.</FONT></P>
Q: How to set selection on List of Values inside a UBE?
A:
1.) Create a dummy section with the same Business View.
2.) Define Data Selection for the dummy section in the Section menu. The Range of Values and List of Values tab will be now available for you.
3.) Use the "Use Data Sel/Seq from a Section" System Function (General Category) in your original Section.
Some more test results (by Sef):
The solution works a treat. There's even no need to call this section at all. All you need to do is create it and hide it.
It seems the following "hierarchy" exists when selection statements interact:
When you use 'Set User Selection' with 'Use Data sel/seq from a section', only the 'Set User Selection' is used.
When you set 'Set selection append flag' = Yes and add some data selection at run time, only the 'Use Data sel/seq from a section' is used.
Sef van den Nieuwelaar
Australia
B732 on NT, XE on NT, B732/A73 on AS400, B733 on NT<P ID="edit"><FONT SIZE=-1>Edited by Sef on 12/16/01 09:44 PM.</FONT></P>
