JMR
VIP Member
Anyone had troubles (or just strange behavior) trying to debug a custom bsfn inside of a table conversion?
When I first tried debugging, I was getting error in jde.log saying:
net program ended, pid=1324, signal=11
My table conversion did not run.
Here comes the wierd part. After trying to research (to no avail) what that means in my context, I logged off and started over. Well, now the TC runs to completion, but I still can not debug. I am in debug mode, I have breakpoints set, it just runs without ever stopping.
I've debugged plenty of C code, so I know I have the correct msvc setup. I put the bsfn in a regular ube and it breaks just as expected. Is there something special about table conversions that would cause this?
Any help is greatly appreciated as I am at my wits end.
Thanks,
When I first tried debugging, I was getting error in jde.log saying:
net program ended, pid=1324, signal=11
My table conversion did not run.
Here comes the wierd part. After trying to research (to no avail) what that means in my context, I logged off and started over. Well, now the TC runs to completion, but I still can not debug. I am in debug mode, I have breakpoints set, it just runs without ever stopping.
I've debugged plenty of C code, so I know I have the correct msvc setup. I put the bsfn in a regular ube and it breaks just as expected. Is there something special about table conversions that would cause this?
Any help is greatly appreciated as I am at my wits end.
Thanks,