Can Any one tell me How To Use Check Data Selection/Sequence System Function.I tried It to Check Weather the Data Item is availabbe in the given Selection/Sequence But i'm not able see the Result.Please Can any one help on this.
Last Modified: B733
CheckDataSelection/Sequence performs a search to see whether a given data item exists within the data selection or data sequencing for a given section of a report. This allows the user to perform certain logic if that data item does or does not exist.
The report template, version name
If any of the parameters is blank or NULL, current report/version will be used.
This parameter must be a valid section from the chosen report.
This flag determines whether the data item will be searched for with the data selection or data sequencing.
This is the data item that will be searched for.
This is the where the return value for the function will be stored. If, after the function is called, this value is zero, then the data item was not found. Otherwise, it will contain the position at which the data item was first encountered.
Special Handling Instructions and Prerequisites
This function is useful in the init section to determine whether to append or replace data selection/sequencing. Based on the design, it can also be used to check if the data selection was overwritten at the version level or not.
Set Data Selection
Set Data Sequencing
Copy Data Selection/Sequencing from another section
Im Just Checking How to use that system function.Here the problem is I have passed the all the parameter as above and in Result tab I have passed RV to know the value but after the function triggered that RV value is showing blank value....So, can u pis help on this.