Blank Page printing from Hidden Section

[Wolly]

Hi,

I have customised a copy of R04572U1. I have changed the properties of all existing sections to be Non Visible(not to print). Within the Payment Selection Section I am writing to a workfile and have created a Custom Section over this new workfile. This new Section should be the only one to print and is called from the End Section of the Driver Section.

However, I am getting blank pages prior to my actual data(from the workfile). I believe that these blank pages are caused by calls to the Payment Selection Custom Section from the Driver Section.

My question is this, has anyone experienced similiar? If so, how have they gotten around it?

Thanks

Wolly

Xe Sp22

 

[developerCH]

Never seen this problem, but sections that have page breaks after or before set might be generating the extra pages. Turn off all page breaking in the properties for all sections

DeveloperCH

 

[snallure]

Have you tried suppress section write?

 

[Wolly]

Hi,

Thanks for the response, it turned out to be a simple explanation that I'd
overlooked. There were page breaks switched on within the Sequencing on the
Payment Selection section. SHould have spotted it earlier.

Thanks again

GW




Xe SP22,
Experience of B7321, B7331, B7332,

 

[Wolly]

A colleague advised me regarding resolution.

Page Breaks were set within Data Sequencing of the Payment Selection section, hence blank pages

Doh!!!

Thanks for the replies and ideas