bvtaylor
Member
When I make the slightest of changes to an event rule the report runs but does not retrieve any data. Where before the change report runs fine. The code below is just one calculation on one variable on one line of a multipage report.
Even if I comment out the code I just added same "No data" message.
//
If RV Description is equal to "COST OF SALES AT STANDARD"
RV mnMtdActualAmtPerUnit = [RV mnActualMTD]/[RV SOLD+USED_MTD(g)]
Else
End If
//
Thanks for any insight you may provide.. Bob
Even if I comment out the code I just added same "No data" message.
//
If RV Description is equal to "COST OF SALES AT STANDARD"
RV mnMtdActualAmtPerUnit = [RV mnActualMTD]/[RV SOLD+USED_MTD(g)]
Else
End If
//
Thanks for any insight you may provide.. Bob