johndanter
Legendary Poster
Hi list,
We have a very intermittent problem here whereby R46171 can sometimes miss locations
The F4600 Requests at are status 200 and are being read by R46171 but they are not always creating the F4611 suggestions for all locations.
Even worse thing is, it isn't even consistent for the SAME location during the run span of the UBE
I.E at the start of the R46171 it was using certain locations and saying everything was fine, then half way through the PDF for the SAME location we then get an error saying...
"Zone does not match"
From then on in, the R46171 then treats that location as being unusable and repeats with the same error 'Zone does not match error'
The only place in E1 where error 3458 'Zone does not match' is created in in N4600220.
There are 3 lines of code in there that spit out that error message
Ln 116, 119 and 192
The decision to display that error or not are made from variables it gets back from:
B4100240 (location) and B4600270 (Request)
As I say, when this happens it stops creating the F4611 and gives that error 3458
However if you reset the the F4600 back to 200 and Resusggest, it WILL use the location is said was in error previously?????
Can anyone help me as this is intermittent and I do not have a 'bad log' only a good log
Many thanks
John
We have a very intermittent problem here whereby R46171 can sometimes miss locations
The F4600 Requests at are status 200 and are being read by R46171 but they are not always creating the F4611 suggestions for all locations.
Even worse thing is, it isn't even consistent for the SAME location during the run span of the UBE
I.E at the start of the R46171 it was using certain locations and saying everything was fine, then half way through the PDF for the SAME location we then get an error saying...
"Zone does not match"
From then on in, the R46171 then treats that location as being unusable and repeats with the same error 'Zone does not match error'
The only place in E1 where error 3458 'Zone does not match' is created in in N4600220.
There are 3 lines of code in there that spit out that error message
Ln 116, 119 and 192
The decision to display that error or not are made from variables it gets back from:
B4100240 (location) and B4600270 (Request)
As I say, when this happens it stops creating the F4611 and gives that error 3458
However if you reset the the F4600 back to 200 and Resusggest, it WILL use the location is said was in error previously?????
Can anyone help me as this is intermittent and I do not have a 'bad log' only a good log
Many thanks
John