scott_parker
Reputable Poster
Greetings,
I have a batch job that is erroring out with the following message in the Job Log.
40 10/19/00 12:07:49 QRGXTIME QSYS 0001 QRGXTIME
Message . . . . : Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing
pointer, that has not been set to an address.
40 10/19/00 12:07:49 QMHUNMSG *N QRGXTIME QSYS
Message . . . . : Function check. MCH3601 unmonitored by QRGXTIME at
statement *N, instruction X'0001'.
Cause . . . . . : An escape exception message was sent to a program which
did not monitor for that message. The full name of the program to which the
unmonitored message was sent is QRGXTIME . At the time the message was sen
the program was stopped at higher level language statement number(s) *N. If
more than one statement number is shown, the program was a bound program.
Optimization does not allow a single statement number to be determined. If
*N is shown as a value, it means the actual value was not available.
Recovery . . . : See the low level messages previously listed to locate
the cause of the function check. Correct any errors, and then try the
request again.
These 2 error messages are just repeated OVER and OVER (killed the job and got a 59,000 page job log)
I know that the Program is at a statement of code that looks like the following
C TIME $TIME120 120
Nothing Wrong with this line of code.
I use the same line of code in another program and it works just fine.
We are on a 4 way AS/400 with OS of V4.R4
Any Ideas?
I have a batch job that is erroring out with the following message in the Job Log.
40 10/19/00 12:07:49 QRGXTIME QSYS 0001 QRGXTIME
Message . . . . : Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing
pointer, that has not been set to an address.
40 10/19/00 12:07:49 QMHUNMSG *N QRGXTIME QSYS
Message . . . . : Function check. MCH3601 unmonitored by QRGXTIME at
statement *N, instruction X'0001'.
Cause . . . . . : An escape exception message was sent to a program which
did not monitor for that message. The full name of the program to which the
unmonitored message was sent is QRGXTIME . At the time the message was sen
the program was stopped at higher level language statement number(s) *N. If
more than one statement number is shown, the program was a bound program.
Optimization does not allow a single statement number to be determined. If
*N is shown as a value, it means the actual value was not available.
Recovery . . . : See the low level messages previously listed to locate
the cause of the function check. Correct any errors, and then try the
request again.
These 2 error messages are just repeated OVER and OVER (killed the job and got a 59,000 page job log)
I know that the Program is at a statement of code that looks like the following
C TIME $TIME120 120
Nothing Wrong with this line of code.
I use the same line of code in another program and it works just fine.
We are on a 4 way AS/400 with OS of V4.R4
Any Ideas?