CHo
VIP Member
Hi. I'm modifying a custom fixed asset report created using fixed asset report writer. I did not create the UBE. I need to debug the report. When I go into the debugger, the ER is different than what's in RDA. I'm positive that I chose the correct UBE in the debugger. I moved the column data selection to the column inclusion event, but I only see the smart field not the IF statement. Also I see references to Rolling Column Headings, but I do not see those lines in RDA.
Is debugger looking at old specs? What is going on?
Is debugger looking at old specs? What is going on?