ErpRob
Well Known Member
I have an interface setup for the fed-ex shipment software. Therefore I provide a file
with various information, i.e. address, COD, Third party billing, etc. and get the
information back via an outbound file.
In the outbound file I get back the City and State in a combined field even though I
send two separate fields. I guess they combine it in the interface. I would like to
extract the city and state. The problem is that in ER you cannot sent the text
character to a DS and work backwards from a loop. How can I set something up. Normally
in the RPG world I would send it to a DS find the first blank after a text field was
found and work it out.
The purpose is if the shipping clerk changed the address because it was wrong. I would
to compare what was sent and update the drop shipment file (F4006) before invoicing.
Any help would be good and If I knew how to write a BSFN I could perhaps solve my
problem. But I do not know C at this time.
thanks
Rob
with various information, i.e. address, COD, Third party billing, etc. and get the
information back via an outbound file.
In the outbound file I get back the City and State in a combined field even though I
send two separate fields. I guess they combine it in the interface. I would like to
extract the city and state. The problem is that in ER you cannot sent the text
character to a DS and work backwards from a loop. How can I set something up. Normally
in the RPG world I would send it to a DS find the first blank after a text field was
found and work it out.
The purpose is if the shipping clerk changed the address because it was wrong. I would
to compare what was sent and update the drop shipment file (F4006) before invoicing.
Any help would be good and If I knew how to write a BSFN I could perhaps solve my
problem. But I do not know C at this time.
thanks
Rob