tiradoj
Well Known Member
Hello Fellow CNC-ers
I have a client on JDE 810 with iSeries V5R4 and I cannot get the server programs (SVRPGMS) to compile. It appears that JDE cannot find the CRTCMOD program in QDEVTOOLS library where it sits. I have ensured QDEVTOOLS was in the library list but still no joy. Here is the log file message.
Any ideas would be appreciated.
Thanks in advance.
Joe Tirado
CNC
Display Spooled File
File . . . . . : QPJOBLOG Page/Line 1/37
Control . . . . . W35 Columns 35 - 112
Find . . . . . .
+....4....+....5....+....6....+....7....+....8....+....9....+....0....+....1..
To module . . . . . . . . . : JDE400U
To procedure . . . . . . . : ExecuteCmd
Statement . . . . . . . . . : 13
Message . . . . : Command CRTCMOD in library *LIBL not found.
Cause . . . . . : If a library was not specified, the command was not fou
in the libraries in the library list. If a library was specified, the
command was not found there. One of the following special values may have
been used to specify the library: *LIBL - The command was not found in th
libraries in the library list *NLVLIBL - The command was not found in the
national language version libraries in the system library list. *SYSTEM -
The command was not found in library QSYS. Recovery . . . : Change the
command name or correct the library name, and then try the command again.
30 12/10/12 00:08:28.522656 QCARULE QSYS 07A7 JDELIB
To module . . . . . . . . . : JDE400U
To procedure . . . . . . . : ExecuteCmd
Statement . . . . . . . . . : 13
I have a client on JDE 810 with iSeries V5R4 and I cannot get the server programs (SVRPGMS) to compile. It appears that JDE cannot find the CRTCMOD program in QDEVTOOLS library where it sits. I have ensured QDEVTOOLS was in the library list but still no joy. Here is the log file message.
Any ideas would be appreciated.
Thanks in advance.
Joe Tirado
CNC
Display Spooled File
File . . . . . : QPJOBLOG Page/Line 1/37
Control . . . . . W35 Columns 35 - 112
Find . . . . . .
+....4....+....5....+....6....+....7....+....8....+....9....+....0....+....1..
To module . . . . . . . . . : JDE400U
To procedure . . . . . . . : ExecuteCmd
Statement . . . . . . . . . : 13
Message . . . . : Command CRTCMOD in library *LIBL not found.
Cause . . . . . : If a library was not specified, the command was not fou
in the libraries in the library list. If a library was specified, the
command was not found there. One of the following special values may have
been used to specify the library: *LIBL - The command was not found in th
libraries in the library list *NLVLIBL - The command was not found in the
national language version libraries in the system library list. *SYSTEM -
The command was not found in library QSYS. Recovery . . . : Change the
command name or correct the library name, and then try the command again.
30 12/10/12 00:08:28.522656 QCARULE QSYS 07A7 JDELIB
To module . . . . . . . . . : JDE400U
To procedure . . . . . . . : ExecuteCmd
Statement . . . . . . . . . : 13