jigarmehta
Active Member
We have a scenario where in we need that after each completion of WO or an IC transaction the lot should go on a default lot status as specified in P41026
I have set up P41026 for a item to go on Lot status as T.
We have partial completion scenario , so once the IC is done for the first time and a new Lot number is generated say 12345 than as per setup the Lot status T is populated on P31114 screen and the Lot goes on hold and Lot status is set to T for that lot. F41021 pqoh is updated but Quantity available is blank (greyed) due to Lot status as T
Quality person will check the lot physically and if found OK they will remove the Lot status from T to Blank , and now F41021 quantity availabe is back.
After few days we do an IC completion for the same Lot but now the Lot status does not get populated with T as per setup in P41026.
Any idea or help would be appreciated since we need that the second completion should also go on hold as it would also be physically inspected and then release by Quality.
I understand we do have a Lot status option where we can enter the Lot status in P31114 but that would be manual control and user can forget it.
We are using 9.1
I have set up P41026 for a item to go on Lot status as T.
We have partial completion scenario , so once the IC is done for the first time and a new Lot number is generated say 12345 than as per setup the Lot status T is populated on P31114 screen and the Lot goes on hold and Lot status is set to T for that lot. F41021 pqoh is updated but Quantity available is blank (greyed) due to Lot status as T
Quality person will check the lot physically and if found OK they will remove the Lot status from T to Blank , and now F41021 quantity availabe is back.
After few days we do an IC completion for the same Lot but now the Lot status does not get populated with T as per setup in P41026.
Any idea or help would be appreciated since we need that the second completion should also go on hold as it would also be physically inspected and then release by Quality.
I understand we do have a Lot status option where we can enter the Lot status in P31114 but that would be manual control and user can forget it.
We are using 9.1