SQLExtendedFetch failed

Has anyone met the issue?

I run the UBE R04413C and it had been finished normally.
But the reuslt was not full. And the log was displayed as below.

5772/6560 MAIN_THREAD Fri Nov 15 16:26:45.964000 Runbatch.c320
INITIALIZING RUNBATCH job: 324458

5772/6560 MAIN_THREAD Fri Nov 15 16:26:45.979000 ipcmisc.c299
process 5772 <runbatch.exe> registered in entry 107

5772/6560 MAIN_THREAD Fri Nov 15 16:26:45.979001 Runbatch.c465
Startup for User=SAPB3390, Env=PDT810, Role=OCMSUP, Job#=324458

5772/6560 MAIN_THREAD Fri Nov 15 16:26:45.979002 Runbatch.c482
bAPListening=0

5772/6560 MAIN_THREAD Fri Nov 15 16:26:45.995000 Netpub.c257
The total of each kernel definition maxNumberOfProcesses is greater than the maxKernelProcesses setting, adjusting maxKernelProcesses to match

5772/6560 MAIN_THREAD Fri Nov 15 16:26:46.557000 zdrv.cpp328
Initializing the Z Driver

5772/6560 MAIN_THREAD Fri Nov 15 16:26:46.557001 zdrv.cpp342
Gettting user data from hEnv

5772/6560 MAIN_THREAD Fri Nov 15 16:26:46.557002 zdrv.cpp364
User data is SAPB3390, PDT810

5772/6560 MAIN_THREAD Fri Nov 15 16:26:46.557003 zdrv.cpp373
Creating XML Session

5772/6560 MAIN_THREAD Fri Nov 15 16:26:48.975453 Odbc_p1.c1679
ODB0000092 - SQLExtendedFetch failed. Table(1st) F0411A, ODBC DSN SAPBSVR09.

5772/6560 MAIN_THREAD Fri Nov 15 16:26:48.975455 Jdb_drvm.c1176
JDB9900172 - Failed to execute db fetch

5772/6560 MAIN_THREAD Fri Nov 15 16:26:49.193004 ipcmisc.c299
API ipcSawUnregisterProcV1 : process 5772 unregistered in entry 107

5772/6560 MAIN_THREAD Fri Nov 15 16:26:49.193032 zdrv.cpp389
Terminating Z driver

5772/6560 MAIN_THREAD Fri Nov 15 16:26:49.193036 zdrv.cpp406
Calling freeSession

5772/6560 MAIN_THREAD Fri Nov 15 16:26:49.271002 Jdb_ctl.c1752
JDB4100005 - Application code leaked 1 data pointers which were detected when freeing environment PDT810 (EnvHandle 0248F778) for user SAPB3390. Please refer to the debug log for details. If there are not enough details in the debug log to determine the cause, set DataPointerTracing=1 and Output=FILE in the [DEBUG] section of the JDE.INI and watch for this error message again. This message will only appear with debug code or when debug logging is turned on.

So has anyone met the same issue?