Tab Sequence Problem - P0411

AmandaHyde

Active Member
Hi Everyone,

I need to change the tab sequence of form W0911A in P0911 to start on the Sequence Number field, then Doc type, then key Company, then Company. But although form design lets me change the tab sequence, when I run the application the tab sequence starts at 'Company' regardless of what I have set it to.

I have checked the properties of the fields and the event rule code for 'set focus...' and 'disable...' code, but I can't see a reason for this and it's driving me crazy!

Any advice would be most welcome!

Cheers
Amanda
 
Hi Amanda,

Be sure that the Default Cursor on Add and Update Mode check boxes are unchecked on the Properties/Options window of Company control.

If they are already unchecked and the tab sequence is not the required then mark these check boxes for the desired start control (Sequence Number).

Please, let us know your results.

Regards,

Zoltán
 
Hi Zoltan,=20

Thanks very much for your help, I found the solution yesterday by reading=20
through some old posts about similar problems. It was the 'Default cursor=20
on Add' box that was checked for the 'Company' field.=20

Regards

Amanda





Zoltan=5FGyimesi <[email protected]>
Sent by: [email protected]
20/02/2003 19:42
Please respond to jdeowdev

=20
To: [email protected]
cc:=20
Subject: Re: Tab Sequence Problem - P0411


Zoltan=5FGyimesi replied to your post at the site: .
http://www.jdelist.com/ubb/showthreaded.php?Cat=3D&Board=3DOWDEV&Number=3D5=
0187

Hi Amanda,

Be sure that the Default Cursor on Add and Update Mode check boxes are=20
unchecked on the Properties/Options window of Company control.

If they are already unchecked and the tab sequence is not the required=20
then mark these check boxes for the desired start control (Sequence=20
Number).

Please, let us know your results.

Regards,

Zolt=E1n
 
You create your own tab sequence and put it under a new format.You can do it
in application level itself. It will work.

Sundaram


----- Original Message -----
From: "AmandaHyde" <[email protected]>
To: <[email protected]>
Sent: Thursday, February 20, 2003 8:02 PM
Subject: Tab Sequence Problem - P0411


start on the Sequence Number field, then Doc type, then key Company, then
Company. But although form design lets me change the tab sequence, when I
run the application the tab sequence starts at 'Company' regardless of what
I have set it to. I have checked the properties of the fields and the event
rule code for 'set focus...' and 'disable...' code, but I can't see a reason
for this and it's driving me crazy!Any advice would be most
welcome!CheersAmanda



OWN STAND ALONE PC WITH WINDOWS 98
 
Sundaram,

Can you explain this further? I am also confused with " You can do it in application level itself".

Ben again
 
Back
Top