Results 1 to 1 of 1

Thread: Disable control system function not working

  1. #1
    New Member
    Join Date
    Jun 2005
    Location
    India
    Posts
    28

    Unhappy Disable control system function not working

    Hi,

    In a button clicked event, Disable Control function is not working.
    Event flow is below.

    Button Clicked Event:

    Disable Control (FC Control)
    //
    Variable = 1000000
    while variable is greater than zero
    variable = variable -1
    FC Control 1 = variable
    end while
    //
    Enable Control (FC Control)

    When control goes to while loop, Form Control should be disabled. But it is not disabling the control. If i remove the enable control event, then it is Disabling the control only after executing the while loop.

    Inside while loop i have assigned a form control variable, but the variable is assigned only 0 when button clicked event is executed.

    Is there anything I am missing? Kindly help.

    Thanks
    Imran
    JDE 9.1
    Last edited by Imrankhan; 10-12-2017 at 04:53 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The legal restrictions and terms of use applicable to this site are available here.
Use of this site signifies your agreement to the terms of use.
JDELIST is NOT affiliated with JD Edwards® & Company, Oracle or Peoplesoft. Contents of this site are neither endorsed nor approved by JD Edwards® & Company, Oracle or Peoplesoft.