Er Debugger Error Message: The parameter is incorrect

carlo.buhay

Member
Hello!

When I attempt to start debug (by clicking on Debug Application in JDE Solution) I get a pop-up that says, "The parameter is incorrect.".
Clicking the OK button of the pop-up will display the ER Debugger screen.
But when I select an object to debug, the pop-up comes up again and basically could not proceed from there.
I am using a fat client and before I had this problem my machine shut off due to low power.
Any suggestions?

I am new to E1.
I did try to look for a discussion about the matter but did not find any.




 
Hi Carlo,

Welcome to the world of JDE and JDEList, where you will find JDE Geeks :p

If this caused due to shut off of the PC ( i.e., without proper Shut Down procedure), some of the required files might corrupted.
Re-installing fat client might solve the issue. I had this kind of issue ( not with debugger, but with RDA), and I just reinstalled fat client and fixed my issue.

Probability for occurring this kind of error is very high if we do not properly shut down the PC. So it is advised to connect to an Uninterruptible Power Supply (UPS).
 
Hello Rauf!

Thank you very much for the welcome and advice.
I was hoping that it would be just a matter of clearing a table or even a folder.
Anyway, I had my fat client reinstalled.
 

Similar threads

Karzmo
E9.2 Localisation Calls - Italy
Replies
2
Views
1K
Karzmo
Karzmo
E9.1 ER Debugger for interactive app
Replies
1
Views
2K
Rauf
Rauf
E9.2 Change Assistant Error for UDOs
Replies
8
Views
560
Seane6
ArnoldWillems
E9.2 Orchestration how to see FREQ updates life in grid row
Replies
9
Views
623
munster
The barcode in BI Publisher template is not generating the output in PDF format
Replies
2
Views
838
Eric Kempter
Eric Kempter
Back
Top