auditing problem

I just enabled auditing and we are getting followign errors in our logs. Has any one encountered this issue. When I started the auditing every thign was workignfine and there was no prolem and we were gettign records in our auditing tables. Suddenly we are getting these errors. Any ideas


JDB9901003 - There is a conflict between auditing flags of table: F0006 among different environments sharing the data source: Business Data - PROD

2124/1140 Mon Mar 21 09:04:19.757 jdb_cfr.c4738
JDB9901003 - There is a conflict between auditing flags of table: F00950 among different environments sharing the data source: System - B9

2124/1140 Mon Mar 21 09:04:19.772 jdb_cfr.c4738
JDB9901003 - There is a conflict between auditing flags of table: F0301 among different environments sharing the data source: Business Data - PROD

2124/1140 Mon Mar 21 09:04:19.788 jdb_cfr.c4738
JDB9901003 - There is a conflict between auditing flags of table: F0401 among different environments sharing the data source: Business Data - PROD

2124/1140 Mon Mar 21 09:04:19.788 jdb_cfr.c4738
JDB9901003 - There is a conflict between auditing flags of table: F0901 among different environments sharing the data source: Business Data - PROD

2124/1140 Mon Mar 21 09:04:19.803 jdb_cfr.c4738
JDB9901003 - There is a conflict between auditing flags of table: F5201 among different environments sharing the data source: Business Data - PROD

2124/1140 Mon Mar 21 09:04:44.772 Jdb_exet.c5064
JDB9901010 - Fail to insert to table (F0901) because there is a conflict in auditing setup

2124/1140 Mon Mar 21 09:04:44.803 Jdb_exet.c5064
JDB9901010 - Fail to insert to table (F0901) because there is a conflict in auditing setup

2124/1140 Mon Mar 21 09:04:44.835 Jdb_exet.c5064
JDB9901010 - Fail to insert to table (F0901) because there is a conflict in auditing setup

2124/1140 Mon Mar 21 09:04:44.850 Jdb_exet.c5064
JDB9901010 - Fail to insert to table (F0901) because there is a conflict in auditing setup

Hello,
I have exactly the same errors.
Have you solved your issue ? If it is the case, please advice me on what to do.
Thanks in advance.
Regards,
Loic BIRY

Hi I did resolve this case, Don't remeber the exact resolution but is a known issue. Call up denver . It is mentioned in the CFR11 guide too.

Hi,
I have also found the solution for my problem : I had set up the audit trail for PD810 but not for JPD810 and my test was made with an HTML client.
After copying the Audit Table configuration, everything works fine.
Regards,
Loïc