BIP Report fails with status FS

andrea banning

Member
I have a situation where UBE1 calls UBE2.
UBE2 has been defined with BIP. When UBE1 calls UBE2 the XML is generated but when you open P95630 to view output the status is FS. I can republish the file and the XML/template merges to status D.
I cannot determine why the called UBE2 will not succeed on the first try when called by UBE1.
I would appreciate any input.
Thank you
 
Hi Andrea

There are a couple of known issues regarding report definitions which are called via a report interconnect. Take a look at this support page and see if they apply to your setup:

https://support.oracle.com/CSP/main/article?cmd=show&type=NOT&doctype=PROBLEM&id=855441.1

If that doesn't help, then try getting the BI Publisher Kernel jas logs and the BI Publisher logs to see if they contain details of the problem that's causing the failure. Details of how to generate these can be found here:

https://support.oracle.com/CSP/main/article?cmd=show&type=NOT&doctype=HOWTO&id=782159.1
https://support.oracle.com/CSP/main/article?cmd=show&type=NOT&doctype=PROBLEM&id=660505.1

Regards,
Dave
 
Back
Top