ROBOT status code not updated properly

cncjunior1

Reputable Poster
I have a few UBEs setup on our test system to run through ROBOT using RUNUBE. One of the jobs in the group keeps failing due to nightly backups running. The job runs for about 15 minutes before failing and the only message in the log is the SIGABRT error. The job shows a status of E in WSJ but the real issue is that the job shows a 'C' for completeing normally within ROBOT and hence continues to execute the next job in the group. Is there a way to get a return code or some other setup that will notify ROBOT of the job ending abnormally when this kind of error occurs? Attached is the AS/400 job log.
 

Attachments

  • 131786-QPJOBLOG198011.txt
    36.4 KB · Views: 1,022
Back
Top