Storing Item Weights

Teri

Member
Is anyone using a JDE designated field in Item Master or Branch Plant to store the weight of an item? All our cat codes are full. I was hoping there was an exit program that contains this information / field that I've missed. Thanks
 
Teri, I sent you a direct email with a screen snap of where you store the weights. It is from Item Master, F8, then F8 again from the UOM screen.
 
Absolutely spot on Ssolberg

You set up the conversion factor from the Primary UOM to the Weight UOM (e.g. EA to KG)...

If you wish to use this for Analysis/Reporting in SOP you should also set the Weight UOM on the Item Master then F8 Screen...

The Total weight of the item on the sales order line is held in Field SDITWT on the F4211.... Note this is the Total Weight and has 4 decimal Places.... (the same applies to the Volume field SDITVL on the F4211)

Note you can also utilise the Secondary UOM field to have the Secondary quantity in SDSQOR on the F4211...

Lots of opportunities.......!!!

Regards

Gareth
 
Back
Top