P0006 Business units appl screen size problem

DEvans

Active Member
While attempting to use the application P0006 we are unable to see the whole
screen. i.e. the bottom third of it was out of sight and no scroll bar was
there to assist. Therefore currently we are unable to setup required
workcentres for CRP test.
Has anyone else seen this, we think it may be an ESU issue as we have a
vanilla setup.

Darren Evans
EnterpriseOne CNC Technical Consultant
Xe Update 6, SP21_N1
Sun Solaris 8
Oracle 8.1.7
Citrix Xpe



The contents of this e-mail are strictly confidential and are intended only for the addressee named above. This e-mail may contain confidential or privileged information. If you are not the intended recipient of this message please notify the sender immediately. The contents of this e-mail must not be disclosed to any other person or copies taken.

Please note that any views expressed in this e-mail may be those of the originator and do not necessarily reflect those of this organisation.

Internet e-mail is not a secure communications medium. Please note this lack of security when responding by e-mail. Accordingly, we give no warranties or assurances about the security and content of this e-mail and its attachments.

Neither Silentnight Holdings Plc nor the sender accepts any responsibility or liability for viruses and it is your responsibility to scan the e-mail and attachments. Any liability arising from any third party acting on any information contained in this e-mail is hereby excluded.

© Silentnight Holdings PLC [2003]. All rights reserved
 
Darren

What is the screen area/setting in the control panel set to? I believe PSFT recommends 1024 X 768.

Patty
 
There is a SAR (6111764) that addresses this. There are ESU's available for both Xe and ERP8
 
Back
Top