XE vs B9 - Visual ER Compare for APPL, UBE

Zoltan_Gyimesi

Zoltan_Gyimesi

Legendary Poster
Hi List,

I have troubles to compair APPLs, UBEs with Visual ER Compare (VERC) under B9 against XE version.

Scenario:
I have a workstation with fat XE and B9 client (switched by snapshot)
I CheckOut/Get P0411 application under both client.
I called VERC for P0411 under B9.
I have choosen Remote Specification Location and point to my spec folder of XE/DV7333 pathcode on my workstation.
VERC can not conjugate B9 and XE forms, almost for all form and this does not allow me to compare and/or move ER between B9 and XE forms.

When I used VERC for our add-on obbjects, worked fine.

On standard UBE/APPL VERC wasn't able to match Sections/Forms, almost for all Section/Form. In these cases VERC show the source site Section/Form blue coloured (indicating, that it exists only on the source site) with name "*** Missing Name***", instead of the name of it. The Sections/Forms appeared again with the real name and green coloured (indicating, that it exists only on the target site)

Where VERC was able to match Section/Form name (red coloured), then wasn't able to match the elements (controls, report variables, etc.).
The elements also lost the name on the source site and are blue coloured,... Just the same like one level higher.

By the way, I can not Copy/Paset Event Rules from XE to B9

Does anybody know, how can I solve this problem, to use VERC efficiently?

Configurations:
XE SP15.1 (22 too) SQL 2000
B9 SP3 SQL 200

All solution, suggestion will be highly appreciated.

Forgive me this long posts.

Regards,

Zoltán
 
Back
Top