TDA add columns to existing years

nkuebelbeck

VIP Member
TDA add columns to existing table

In the past I've had to have our cnc guy copy the table, regenerate the table, then put the data back. The new columns not being populated with data.

I'm curious if there is a JDE way to accomplish this same task.
 
Last edited:

jdelisths

Reputable Poster
You should be able to do this using R98403 using the table (you want to generate/copy) as data selection. Make sure that the processing options are set correctly, otherwise you will end up doing something you did not intend. You can run this in proof mode.
 
Top