Tabular Section Level Breaks

Bill_Feeney

Active Member
Hi All,
This seems like a dumb question, and I think I know the answer, but I sure could use a quick verification.
In the data sequencing/Define Sort Properties dialog box if I have 4 fields(F0901/F0902 SBL, SUB,OBJ,MCU) and set a level break on each of these I should get totals for each level I'm breaking on, shouldn't I?
So the report would look like:
SBL (Highest)
SUB
OBJ
MCU (Lowest)
AND THE DESCRIPTION would equate to the level of detail currently being processed, right?

I appreciate this quick sanity check. I have a short deadline for a report and I'm not too experienced on these tabular sections.

Thanks,

Bill Feeney
B7332 SP 13.1 Sun Unix Oracle 8.1.6
 

Bill_Feeney

Active Member
Jane, you know the old saying "Better late than never". I appreciate the
reply very much.

Thank You,

Bill Feeney
JDE Technical Developer
B733.2, SP 13.1, Unix, Oracle 8.1.6




Bill Feeney
B7332 SP 13.1 Sun Unix Oracle 8.1.6
 
Top