rekblad
Well Known Member
In the Item Master the item primary UoM = MT with a conversion to MM of 1000 MM = 1 MT.
In BoM, the quantity is .05 MM. When I create a work order for 100 I expect to get a parts list with 5 MM, but instead it is 5,000 MM.
If I change the BoM to have the same PRIMARY UoM of MT, then it works OR change the primary to MM, then it works. But if I use another UoM, the parts list attached to the WO is wrong.
Is it a "rule" that I have to use the primary UoM in the BoM? Geeeez I hope not..... Is this a known error? Am I doing something wrong?
Xe / Sun / NT
Thanks,
Rob
In BoM, the quantity is .05 MM. When I create a work order for 100 I expect to get a parts list with 5 MM, but instead it is 5,000 MM.
If I change the BoM to have the same PRIMARY UoM of MT, then it works OR change the primary to MM, then it works. But if I use another UoM, the parts list attached to the WO is wrong.
Is it a "rule" that I have to use the primary UoM in the BoM? Geeeez I hope not..... Is this a known error? Am I doing something wrong?
Xe / Sun / NT
Thanks,
Rob