Full builds B7332

gtatravel

Member
I am having problems doing full builds tne client side almost finishes
but comes up with an application error (BUSBUILD.EXE) Memory can not be read. Doing builds from my pc normally no problem as deployment server is on Xe7333 already.


HERE IS PART OF THE LOG

8/10/01 22:35:54 0 Finished creating Indexes for table SMRTTMPL.
8/10/01 22:35:54 0 Spec file SMRTTMPL finished.
8/10/01 22:35:54 0

This is where the build ends in error Busbuild application error and stops.

Below is what should happen to complete the build any suggestions why I am getting this busbuild application error.

20/01 07:30:40 0 Start copying NER .c and .h files to checkin location. Failing to do these event rules any ideas??????
1/20/01 07:33:14 0 Finish copying NER files to checkin location.
1/20/01 07:34:25 0 Final size of spec files: count 40 size 1098091213.
1/20/01 07:34:25 0 Check for compression Records.
1/20/01 07:37:12 0 Successful Build of Pa

AS400 v4r5 sp14.2 b7332 wts citrix 1.8 deployment ser (NT-4)

Regards Dave
 

brother_of_karamazov

Legendary Poster
Make sure that you have the following line in the
[Install] section of the building machine's jde.ini:


WaitForBusbuild=Y

This will make the BusBuild and Spec Build run
non-concurrently. If you already have this line and
your deployment server is memory-challenged (<512MB),
try rebooting the deployment server prior to a package
build.



--- gtatravel <[email protected]> wrote:
http://198.144.193.139/cgi-bin/wwwthreads/showflat.pl?Cat=&Board=OW&Number=18633


__________________________________________________
 
Top