I suppose your current sys conf is XE. Am I right?
If yes then do not seek for Build Debug.
Open the Debug Application, select your APPL/UBE in the object window and double click it (or drag?).
I am sure you will quicly understand the user interface of the debug application.
Just one thought. There isn't Find in the object selection window and ALT+I also doesn't work. Symply switch (and back) the APPL/UBE tabs on this window to perform a Find based on QBE entry. Is it tricky?
Read you later,
P.S.: When will your classroom session end?
Excuse me, please.
I was confused by the long conversation (like a cartoon on the Forum) that we did on your Page Number issue, further Forum was opened in two window for the to OneWordl XE Forum in the same time.
In the hope of forgiveness,
P.S.: Who does not work, won't make mistake.