Data Selection and Report Interconnects

[MaritS]

We have an in-house application calling an R56 version that is attempting to utilize both Data Selection and Report Interconnects. When running the UBE standalone, all the Data Selection is used. However, when calling that same version from the application, it appears that only the Report Interconnects are used and all data selection is ignored. I have verified that all the Set User Selections for the Report Interconnects are set to 'And'. Does anyone have any ideas or is data selection ignored when using Report Interconnects? Any help is appreciated.

 

[RussellCodlin]

It is likely how the report interconnect data selection has been programmed. Rather than adding to the existing section data selection it will be replacing it. You'll need to open up your R56 report and change the flag so that the data selection is appended.

 

[peterbruce]

Did you use the system function set selection append set to yes?

 

[MaritS]

That was it!!! Thank you both!!! I completely forgot about that function.