Configurator-Mapping "Order Type" to a segment

Michael Marshall

Member
I'm attempting to map "Order Type" to a segment in the configurator as we have different packaging behaviors depending on if its warranty or not. So far what I did was write a C-Rule where my Derived Calculation is &IHDCTO (F553201) Similarly, I use &IBMCU to pull in Branch Plant.

While the Branch Plant works perfectly, I think the attempt to get Order Type via &IHDCTO fails because it is Header Level data.

Any direction on how to map this would be appreciated.

Michael
 

Similar threads

E9.2 Set up of a process to restrict backorders using Sales Orders in JDE
Replies
3
Views
229
marinescu
E9.2 Set up of a process to restrict backorders using Sales Orders in JDE
Replies
0
Views
187
marinescu
E9.1 Creating a Sales Order for DocType SA Generating an Error
Replies
5
Views
1K
cribeiro
E9.2 How to prevent soft commitment on sales order for line type W
Replies
1
Views
741
Larry_Jones
Larry_Jones
E9.2 Cancel order, but unable to cancel due to Address type Invalid
Replies
1
Views
943
Craig_Potter
Craig_Potter
Back
Top