karenet
Active Member
Hi list,
I have a situation where I had to make a change to an existing home grown JDE table. I wound up deleting 1 column from the existing/old layout, and added a column with a new name and length to the end of the layout. I regenerated the table and index (only 1 primary index) without any problems and checked it back into the server.
My problem is that I cannot access the table anymore using existing UBE's created before the table change. The existing UBE's were fully tested and working before the table change took place. Someone said that I may have to rebuild the SQL-Base out on our AS400 server? [not sure if SQL-Base is correct]
Any help will be greatly appreciated on this. Thanks in advance.
K
AS400, XE, SP16
I have a situation where I had to make a change to an existing home grown JDE table. I wound up deleting 1 column from the existing/old layout, and added a column with a new name and length to the end of the layout. I regenerated the table and index (only 1 primary index) without any problems and checked it back into the server.
My problem is that I cannot access the table anymore using existing UBE's created before the table change. The existing UBE's were fully tested and working before the table change took place. Someone said that I may have to rebuild the SQL-Base out on our AS400 server? [not sure if SQL-Base is correct]
Any help will be greatly appreciated on this. Thanks in advance.
K
AS400, XE, SP16