B7322 RDA

sshepard

Active Member
We went live recently and have modified the R43500 PO Print report to our
liking ... except the gap that is left at the bottom of each page. I have
search for page breaks, etc., but cannot find the reason for this 4" or so
gap at the bottom of each page.

Does anyone have any suggestions regarding elimination of this gap down to a
reasonable, say, 1" margin ?



Steve Shepard
O'Gara - Hess & Eisenhardt
(513) 881-5477
[email protected]
 
FW: B7322 RDA

Regrets - This was supposed to say we went live on B733.2, not B732.2.

SS
 
Re: FW: B7322 RDA

Hi Steve,
have you looked to see if a special form is indicated ? (in rda, report, report properties). if so, check the print set up under report tab and make sure it is set to a full page size and not a custom height and width.
good luck,
dave
.

NT 4.0 SP5, SQL 7.0, One World B7321 SP12.4, Citrix 1.8 (XE soon)
 
RE: FW: B7322 RDA

Dave - Thanks for responding regarding the 4" blank gap we have at the
bottom of the PO Print report.

This was your response ...

Hi Steve,
have you looked to see if a special form is indicated ? (in rda, report,
report properties). if so, check the print set up under report tab and
make sure it is set to a full page size and not a custom height and width.
good luck,
dave
.

NT 4.0 SP5, SQL 7.0, One World B7321 SP12.4, Citrix 1.8 (XE soon)
--------------------------

** > I checked both the versions and the report itself, in the RDA. All, in
the "Advanced" tab, on Properties, have only the TRANSACTION PROCESSING
"ENABLED" checked. Everything else is blank on that tab.


>> We have not, but are soon to, install the two monster ESUs. We are
currently running B733.2, SP 11.3.

Any suggestions ?

>
 
RE: FW: B7322 RDA

Dave - Thanks for your response.

Checked both the report and the versions - Neither have the CUSTOM box
checked.

Any other thoughts ?

SS

>
 
Steve
Look for SAR 4165216, this should take care of your problem.

Mike Lunger

XE SP14 AS400
----- Original Message -----
From: sshepard <[email protected]>
To: <[email protected]>
Sent: Monday, February 19, 2001 9:03 AM
Subject: B7322 RDA


> We went live recently and have modified the R43500 PO Print report to our
> liking ... except the gap that is left at the bottom of each page. I have
> search for page breaks, etc., but cannot find the reason for this 4" or so
> gap at the bottom of each page.
>
> Does anyone have any suggestions regarding elimination of this gap down to
a
> reasonable, say, 1" margin ?
>
>
>
> Steve Shepard
> O'Gara - Hess & Eisenhardt
> (513) 881-5477
> [email protected]
>
>
>
>
> --------------------------
> To view this thread, visit the JDEList forum at:
>
http://198.144.193.139/cgi-bin/wwwthreads/showflat.pl?Cat=0&Board=OW&Number=
5813
> *************************************************************
> This is the JDEList One World / XE Mailing List.
> Archives and information on how to SUBSCRIBE, and
> UNSUBSCRIBE can be found at http://www.JDELIST.com
> *************************************************************
>
 
Back
Top