mezereo
Member
Hi,
Let me start with saying that I'm new to RPG programming and AS400 systems.
We have a custom UBE which ends in Error when run on the server (AS400) only for a particular order number (runs without any issues for all other orders). For the same order number, it runs fine when run in LOCAL.
The jde logs dont have any information regarding the issue/error but I found the below error in the AS400 job log:
40 24/12/14 21:0:49 JDEKRNL B7334SYS *STMT JDEKRNL
B7331SYS *STMT JDELIB B7331SYS *STMT
From module . . . . . . . . : JDECM_RB
From procedure . . . . . . : RBTREE_FindPtr
Statement . . . . . . . . . : 1
To module . . . . . . . . . : JDECM_RB
To procedure . . . . . . . : RBTREE_FindPtr
Statement . . . . . . . . . : 1
Message . . . . : Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing pointer, that has not been set to an address.
We tried to restart the services, submit the UBE specification on the server but nothing works. Interesting part is, the UBE does end up successful once in a while for this order number.
Any ideas/pointers on where else to look for this issue.
Appreciate any help or guidance.
Thanks,
B7334, SP23, AS400
Let me start with saying that I'm new to RPG programming and AS400 systems.
We have a custom UBE which ends in Error when run on the server (AS400) only for a particular order number (runs without any issues for all other orders). For the same order number, it runs fine when run in LOCAL.
The jde logs dont have any information regarding the issue/error but I found the below error in the AS400 job log:
40 24/12/14 21:0:49 JDEKRNL B7334SYS *STMT JDEKRNL
B7331SYS *STMT JDELIB B7331SYS *STMT
From module . . . . . . . . : JDECM_RB
From procedure . . . . . . : RBTREE_FindPtr
Statement . . . . . . . . . : 1
To module . . . . . . . . . : JDECM_RB
To procedure . . . . . . . : RBTREE_FindPtr
Statement . . . . . . . . . : 1
Message . . . . : Pointer not set for location referenced.
Cause . . . . . : A pointer was used, either directly or as a basing pointer, that has not been set to an address.
We tried to restart the services, submit the UBE specification on the server but nothing works. Interesting part is, the UBE does end up successful once in a while for this order number.
Any ideas/pointers on where else to look for this issue.
Appreciate any help or guidance.
Thanks,
B7334, SP23, AS400